Honda Car Forum

logic_tech15 · #1 (**permalink**) 23 Sep 2009, 07:46 pm

i bought a 1991 civic and swapped out the motor for a 94 Acura integra LS...

But when i turn the car on all the power works but when i turn it to on the car just dies no crank or anything.

any ideas what it could be?

Some wires by my ECU r pulled out by the pins could that affect it?

Honda-Licious Tuning · #2 (**permalink**) 23 Sep 2009, 08:01 pm

Some of the pins on the harness plugs could be bent and that could be your problem. Pull out each plug carefully and check for damage. Your timing, throttle, idle, and mix might be off so check that after you check your harness out.

booga · #3 (**permalink**) 23 Sep 2009, 08:16 pm

check the dash harnesses

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
89 civic hatch no spark? Swapped jdm d15b motor what do I do?	Jesus R	Honda Technical	2	27 Nov 2008 05:01 pm
I just swapped an EX motor into my DX model civic and haveing problems starting?	viper7232	Honda Technical	4	15 Oct 2007 11:06 am
my 2000 honda accord v6 wont start could it be a crank sensor?	corrinne m	Honda Technical	2	01 Oct 2007 05:36 pm
98 civic wont start or crank weather below 15f	oldho69	Honda 2	4	28 Jan 2005 04:22 pm
installed new motor, crank, no start	92dohcvtec	Acura	1	23 Dec 2003 07:17 pm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)