Honda Car Forum

I found some good info in these two threads:

Here

and

Here

I'm the kinda guy who likes pictures so I posted one here.

I did a nice write up along with it which can be found here.

Otherwise here are the directions, enjoy:

1. If you are changing the bulb on the driver’s side, start the engine, turn the steering wheel all the way to the right, and turn off the engine. If you are changing the bulb on the passenger’s side, turn the steering wheel to the left.

2. Use a flat-tipped screwdriver to remove the holding clip from the inner fender. (ed note: be sure to firmly hold the base of the clip while slowly prying the center piece with the screw driver. If you break the clip you can buy a new one. You only need to remove the 1 single fender clip as show in the honda_civic_replace_turn_signal_99.jpg picture.)

3. Pull the inner fender cover back. (ed note: just enough to get your hand in there, you don’t need much room)

4. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

5. Remove the burned out bulb from the socket by pushing it in and turning counterclockwise until it unlocks

6. Install the new bulb in the socket. Turn clockwise to lock it into place (ed note: care should be taken as to how you seat the bulb. There are two ways the bulb can go in, one will turn, the other wont. You will notice that the pins that protrude from the side of the bulb are of different dimensions, this is so that the flashing filament faces away from the car and the parking filament faces inward relative to each side of the car)

7. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

8. Test the lights to make sure the new bulb is working.

9. Put the inner fender cover in place. Install the holding clip and tighten it securely.