Honda Car Forum

...direct swap?

Yes you can put an aftermarket power window system but not direct swap.

not unless the wiring harness supports this ,and most cars built today either have them or they don't ,adding them is really expensive to do,i did this on a Toyota and it cost more than it was worth,but the customer wanted it done,you need to check and see if the car came with the axillary wiring harness already installed,the wires will be located in the door if it came equipped with it,if not its going to be really hard and expensive to do this,good luck.

Yes you can add power windows and yes it will be a direct swap. All you need are 98-02 Accord LX or EX power window parts and swap them on. It would be easier to just buy the driver and passenger doors for those not mechanically inclined. But yes IT IS a direct swap, you have plugs in your cars wiring hiring harness that will connect to the power window plugs. I've did it to my Civic so I'm telling you from experience.

Let me get in on all this good stuff as well. For as what my two cent is worthYou should be able to put them right on with no problems.If you look behind your kick panelsyou should see the plugs for the electric doors.Must cars that i know of as these plugs in them .

If the doors come off of the same type of car, then yes. If not you can still put electric windows if you are any kind of mechinic incline. You will have to chang the manual regulator, for a electric one, and mount the motors, add switches and wires, make sure you fuse to power feeds. They make after market kits for this swap out.

yes of course you can put electric windows on it, it should be a simple job reely and would only take about an hour or sumit normaly the wiring is already there but if yours isnt just go on a couple of websites then email them asking how to wire the electric windows up and they should email back i hope this helps

yes it will honda set up the civics and accords with the harness already set up for the swap from the 96+ civic and the 98+ accord. just find the connections on the wire harness and they will connect right into it. everything should be prewired into the car. just add the doors and you got power windows.