Honda Car Forum | ![]() |
|
|||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| Honda Parts Search |
|
| ||
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
A lighter flywheel allows your engine to rev up faster because of less rotational mass. The clutch is designed to withstand more power produced from the engine to allow a better engagement to the transmission. You only need these when you add over 100 hp to your car or more. The stock clutch will burn up faster because it will be more difficult for it to grip the flywheel when it spins and that causes bad launches and slipping between the flywheel and transmission input shaft speeds. Cons are that your clutch may be heavier and more difficult to modulate, and there may also be chatter when you engage and disengage your clutch, which is nothing to worry about unless it is loud, which can mean it was installed poorly. Also, you may stall out more frequently while you get accustomed to it.
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where and how much can i get a stage 1 turbo for 2000 civic si? | blank | Honda Technical | 1 | 16 Sep 2007 03:30 pm |
| Will 97 honda prelude tiptronic flywheel bolts fit prelude Manual transm. flywheel? Will Civic MT... | Davinci | Honda Technical | 1 | 07 Sep 2007 05:04 pm |
| Final stage resistor? | Dean Dark | Acura | 0 | 26 Jun 2007 08:15 pm |
| Bearing on Flywheel | MikeLikes | Honda 3 | 6 | 30 May 2007 07:08 pm |
| clutch & flywheel | bob | Acura | 4 | 10 Oct 2003 09:25 am |