Honda Car Forum

And hopefully one that will produce the best results? Approximate cost? Difference between short ram and regular?

just hook the hose from your clothes dryer to it, and let it hand down...or cut a hole in the hood and rivet the hose to the top of the hood

AEM and Injen are the best. They're approximately $200. And probably take less than 30 minutes to install with basic tools (socket set and screw-driver)Personally, on my car I have a SRI. The performance gained by a CAI over a SRI are minimal (maybe 1 hp), but the peace of mind due to the reduced risk of hydrolocking is well worth it.BTW, hydrolocking is when water gets sucked up the intake and into the engine by driving through a puddle. The piston hits the water in the cylinder and, since water does not compress, the result is a catastrophic failure of the engine (broken pistons, rods, head, block or all of the above)

Go to this site, you will get lots of info,http://www.8thcivic.com/forums/index.php

AEM, but beware it maybe a little bit of a bitch. i had a 01 celica and with the japs you have to take so much parts off to put it in. but if you know everything on a car its not a problem!!

They are ALL easy to install. If you cannot install one yourself, you should not be working on the car.Short ram is easier, but don't give you much HP gain. Your best bet us cold air instake. AEM CAI should be around $200, and the pipe goes under the front bumper (Which means every time you want to clean thins thing, you either have to lower the bumper or remove the wheel splash guard)