Honda Car Forum

Jake L · #1 (**permalink**) 17 Oct 2007, 12:42 pm

where is the best spot to run the turbo oil inlet line from on a 1996 civic with the stock d16?

stephen b · #2 (**permalink**) 17 Oct 2007, 12:45 pm

Routed behind the turbo itself with PLENTY of heat sheilding

zeleftikam · #3 (**permalink**) 17 Oct 2007, 12:48 pm

If you are asking where you should tap into the oil system to feed the oil to the turbo, I would recommend a filter block adapter that fits between the oil filter and the engine block. Then, you can tap some pressurized oil from there. You could also use the fitting on the back of the block where the oil pressure switch screws in, but I'm not sure how much flow that would give you.

hondab16tuner · #4 (**permalink**) 17 Oct 2007, 12:51 pm

you need to put a brass "t" where your oil pressure sending unit is at. It is right beside the oil filter is.

chinochang · #5 (**permalink**) 17 Oct 2007, 12:54 pm

buy a moroso oil pan. or one that is tapped already..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what is the inlet size of the stock muffler on a 1998 honda civic dx??	boostboi	Honda Technical	1	05 Oct 2007 10:16 am
Is it possible to add on twin turbo, supercharged part to a stock civic coupe?	Nic Gonzales	Honda Technical	6	03 Sep 2007 12:46 pm
If I'm going to install a header for 2000 Integra LS (stock), what size should the inlet...	coolhandbond	Acura Technical	4	25 Aug 2007 03:12 am
What is the diameter of the inlet pipe on a 2005 honda cr-v stock muffler?	Jake Z	Honda Technical	2	23 Aug 2007 11:42 am
line-in for honda civic stock stereo	sanosake@gmail.com	Honda 3	2	29 Dec 2004 07:53 pm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)