Honda Car Forum

I have 18 size rims and i was wondering how low i can go on my car with out having problems with the tires rubbing. I don't have tires yet so if you have any suggestions with that as well, it would really help.rims are 18x7. thank you

Rule of thumb is, the more metal you roll on, the less you can drop a car. You can go about a 1.5" MAX. You should have a pretty nice stance with a 1.5" drop.Check out H&R Springs. They are qouting a 1.3" drop, but it'll probably end up being about 1.4" after they settle.I would go 17" rims (+2 inches) and drop it...rubber is a bit cheaper and the car still sits pretty nice. Remember to upgrade your shocks too. Might as well while you have the tech under the car. You'll have to do it sooner than later putting cut springs on the car.Happy 2ning































www.hrsprings.com

it depends if you have coilovers if you do then you can adjust the height of your car and if you dont then i recommend you get stiff springs and lower it about an inch away from the rims

Check out Eibach springs. They are very good and you can find different drops for them. Or if you want to spend a lot of money, try a TEIN coilover suspension system. These are good cause you can adjust the height and travel right from the drivers seat.