Honda Car Forum


 

Go Back   Honda Car Forum - Accord Parts Civic Tuning Acura Racing > Discussion > Honda Technical

Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 14 Feb 2013, 01:33 pm
Junior Member
 
Join Date: Feb 2013
Posts: 1
Default Replacing clutch on 2007 civic si?

I want to replace the clutch on my 2007 civic si bc I've installed a supercharger and the stock clutch will slip a little in 3rd gear while accelerating hard. I already bought a new clutch, flywheel and pressure plate. my question is in regards to doing it on the ground. will i have to drop the the entire K member or is there room to pry down on it w/ only that sides bolts out to remove the transmission? I've changed transmissions this way on a lift on a ton of nissan cars but I've never done it on a honda.
Reply With Quote
  #2 (permalink)  
Old 14 Feb 2013, 01:46 pm
Member
 
Join Date: Feb 2010
Posts: 98
Default

I think you can get the tranny out with completely removing the sub frame. I do know it will be alot easier to remove the whole sub frame so its out of the way. that is especially true if you are doing it on jack stands.
Reply With Quote
  #3 (permalink)  
Old 14 Feb 2013, 02:01 pm
Junior Member
 
Join Date: Feb 2013
Posts: 23
Default

Save youserlf the headache and time. Remove the compelete frame because at the end, you will have to remove it especially doing it on the ground. Hoist the engine at the top, then drop the transmission below. Good luck.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing a clutch on 96" honda (labor cost)?? DirkDangler Honda Technical 5 02 Feb 2008 11:01 pm
Acura 3.2TL 98 - replacing the a/c clutch? bob Acura Technical 4 17 Aug 2007 01:00 pm
WHAT CAN BE INSPECTED WHEN REPLACING CLUTCH RELEASE BEARING? Matt Acura 4 16 Apr 2007 03:15 pm
WHAT CAN BE INSPECTED WHEN REPLACING CLUTCH RELEASE BEARING? Matt Honda 2 0 13 Apr 2007 02:11 pm
Replacing clutch on a 1997 Civic? Moorehead Johnson Honda 3 1 03 Dec 2004 01:34 pm


All times are GMT -5. The time now is 06:11 am.


Attribution:
Honda News | Autoblog
Powered by Yahoo Answers




Powered by vBulletin®
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
LinkBacks Enabled by vBSEO 3.6.0 PL2 © 2011, Crawlability, Inc.
HondaCarForum.com is not affiliated with Honda Motor Company in any way. Honda Motor Company does not sponsor, support, or endorse HondaCarForum.com in any way. Copyright/trademark/sales mark infringements are not intended or implied.