Honda Car Forum

Hi,
I am replacing a cv axle on a 92 accord.
I got the old one out w/o problems, but I just cannot seem to manage to
lock the new one back into the tranny. The splined end goes in 1/2 way
and then seems to hit on something and not move any further. Is it a
matter of pure "force" or is there some "trick" to get it into the
tranny? Is a hammer necessary?

Thanks!

1bolt_atatime wrote:
> Hi,
> I am replacing a cv axle on a 92 accord.
> I got the old one out w/o problems, but I just cannot seem to manage to
> lock the new one back into the tranny. The splined end goes in 1/2 way
> and then seems to hit on something and not move any further. Is it a
> matter of pure "force" or is there some "trick" to get it into the
> tranny? Is a hammer necessary?
>
> Thanks!
>
the retainer spring [that circlip thing at the end of the splines] is
dropping down in its slot and blocking progress. hold it in place with
a dab of grease - not too much, especially with an automatic. the shaft
should then pop in without undue force.

Also, sometimes the CV axle shafts are rebuilt without much quality
control. Check the splines and dress them up with a file if needed. Good
Luck.