Honda Car Forum

I have a 1991 Accord EX with 160,000 miles on it.

About a week and a half ago the power locks all of a sudden stopped
working. They don't work from any of the 4 doors.

However, from the inside edge of the driver's side door (near where it's
hinged) I can still hear a slight clicking when I use the power lock
switch.

Has anyone had a similar problem? I haven't had the time to check out the
fuses yet, could it be that simple?

Any and all help is appreciated.
Thanks,
Tom

> I haven't had the time to check out the
>fuses yet, could it be that simple?

Haha, u wish.




____________________________________
Do not write below this line. Reserved for me.

tmGallagher wrote:
>
> I have a 1991 Accord EX with 160,000 miles on it.
>
> About a week and a half ago the power locks all of a sudden stopped
> working. They don't work from any of the 4 doors.

Give us some more details. Do the power locks work when using the key
from the outside, but not using the switches on the inside? Vice versa?
Do the power locks not work at all, regardless of how you try to operate
them?

In article <3788ac37c7b4f5115e8a5af1869aeb66
@localhost.talkaboutautos.com>, tgallagher78@yahoo.com posted
the following, uh, drivel...
> I have a 1991 Accord EX with 160,000 miles on it.
>
> About a week and a half ago the power locks all of a sudden stopped
> working. They don't work from any of the 4 doors.
>
> However, from the inside edge of the driver's side door (near where it's
> hinged) I can still hear a slight clicking when I use the power lock
> switch.
>
> Has anyone had a similar problem? I haven't had the time to check out the
> fuses yet, could it be that simple?
>
> Any and all help is appreciated.
> Thanks,
> Tom
>
>
you need a new lock actuator, located inside the door
--

**:::::>>:§«:*´`³¤³´`*:»§:<<:::::**
.·°~ §LëAzZÿ WëA§ëL ~°·.
**:::::>>:§«:*´`³¤³´`*:»§:<<:::::**

{ô¿ô} WrOnG NuMbEr RoCoCcO, yOu .·°~ §LëAzZÿ WëA§ëL ~°·.

I had the same problem.. If you take off your door panel, there is a
control box in the door. If you open that up, there is a circuit board
that the clicking noise comes from. If you look carefully, most likely
one of the solders on the bottom, under one of the white boxes is broken.
Simply re-solder that spot and it will work like a charm. Put a
screw-driver on that spot before to check it. It is not obvious that
there would be a problem, but there is.