Honda Car Forum

I had the same problem. I found in this web site information how to reset. It was topic 5639 or 5917. It was as follows:

The keyless entry stopped working due to a low voltage. The unit must be reset, if you still have the factory radio installed. Procedure as follows: Put key in ignition, turn the ignition all the way on without starting the car. There is a button (does not look like a button) on the factory radio between the AM/FM button and the TAPE/CD button. It is a skinny, long bar. Press and hold the skinny button until you hear the door locks cycle one time, don not release the button. Then press and hold the keyless remote lock button until you hear the locks chcle one time. If you have more than one remote, you must do this for each one. If you mess up during the process, you must turn the ignition off and start over.

IT WORKED. - but only on the first remote. When I programed the second remote, the first one did not work. Hoping someone has an answer for this.

"DewChugr" <dewchugr@insightbb.com> writes:

> If I can send attatchments here there should be a pdf with this message
> showing how this is done. Never tried this before.

Congratulations, but posting binary attachments on text-only groups is a big
no-no. So, this should be your first, last, and only attempt.

Sorry, I'll not do that again.
---
http://dewchugr.home.insightbb.com/ - Web Design
Chris Aseltine <ophidian@newsnation.com> wrote in message
news:2YKNb.63189$Rc4.223579@attbi_s54...
> "DewChugr" <dewchugr@insightbb.com> writes:
>
> > If I can send attatchments here there should be a pdf with this message
> > showing how this is done. Never tried this before.
>
> Congratulations, but posting binary attachments on text-only groups is a
big
> no-no. So, this should be your first, last, and only attempt.
>
>