Honda Car Forum

Yesterday the speedometer on my 1988 Prelude S finally bit the dust. It has
been jumping around for about a year. Today I noticed that the Check Engine
Light came on -- so I pulled the carpet to get a look at the ECU. It read a
Code 2-- "Vehicle Speed Pulser" in the shop manual.

Would this be consistent with a speedometer cable breaking, or do I have a
bad sensor? I know my cable is bad because the whining sound that goes with
the jumpy speedometer is gone.

I thought this assembly was all mechanical on my car-- but I obviously have
a sensor also?

Any advice is most appreciated.

Thanks,

Matthew Brown
Memphis

yes, the two are directly related. sounds like a cable.

the pulser is driven off the speedo. when the cable breaks, the pulser
gets no signal as well as the needle not working.

Matthew Brown wrote:
> Yesterday the speedometer on my 1988 Prelude S finally bit the dust. It has
> been jumping around for about a year. Today I noticed that the Check Engine
> Light came on -- so I pulled the carpet to get a look at the ECU. It read a
> Code 2-- "Vehicle Speed Pulser" in the shop manual.
>
> Would this be consistent with a speedometer cable breaking, or do I have a
> bad sensor? I know my cable is bad because the whining sound that goes with
> the jumpy speedometer is gone.
>
> I thought this assembly was all mechanical on my car-- but I obviously have
> a sensor also?
>
> Any advice is most appreciated.
>
> Thanks,
>
> Matthew Brown
> Memphis
>
>