Honda Car Forum

I don't know if my previous post went through so bear with me if this
is a duplicate post.

I'm replacing the PCV valve of my '87 Accord LX. After pulling the
valve I discovered that the grommet was very brittle and inadequate
for providing proper seating/sealing for the valve, so I decided to
replace it.

The problem is to get the grommet out in one piece... it keeps
breaking in pieces. My concern is that pieces may fall inside the
intake manifold PCV valve hole. I noticed that the valve connects
through the manifold to a tube underneath... the grommet sits between
the manifold and this tube. All of the upper lip of the grommet has
ed and fallen off in pieces. Will I have to remove the manifold in
order to get the lower part of the grommet?

Please help!

Regards,
MC

In article <72bfdbef.0310041652.44f8ad5a@posting.google.com >,
mcruz@rochester.rr.com (bknight) wrote:

> I don't know if my previous post went through so bear with me if this
> is a duplicate post.
>
> I'm replacing the PCV valve of my '87 Accord LX. After pulling the
> valve I discovered that the grommet was very brittle and inadequate
> for providing proper seating/sealing for the valve, so I decided to
> replace it.
>
> The problem is to get the grommet out in one piece... it keeps
> breaking in pieces. My concern is that pieces may fall inside the
> intake manifold PCV valve hole. I noticed that the valve connects
> through the manifold to a tube underneath... the grommet sits between
> the manifold and this tube. All of the upper lip of the grommet has
> ed and fallen off in pieces. Will I have to remove the manifold in
> order to get the lower part of the grommet?
>
> Please help!
>
> Regards,
> MC

I have never tried to do this type of work on a 1987 Honda Accord. My
suggestion based upon what you wrote is to go ahead and remove the
manifold. You should buy a new manifold gasket prior to removing the
manifold.