Honda Car Forum

Hi there,

Did the timing belt on my bro-in-laws 01 accord today. Other than having to
bring it to a shop so they could zap the crank pulley bolt off with their
MASSIVE 1600 ft-lb gun... (this thing looked like a jackhammer, seriously...)
It was a Chicago Pneumatic CP5000. 3 short burps and it was off. The
previous 8 attempts with other tools obviously unsuccessful...

However, The tension has me slightly baffled. We followed factory
instruction, loosen tensioner, rotate crank pulley counter clockwise so that
3 teeth on the camshaft go by... etc etc

The t-belt seemed to have good tension, but the balance shaft belt was (i
thought) a little loose. nowhere near flying off, but i hope you get my
point.

Any input or pointers regarding timing belt/balance belt tension is
appreciated.

Thx
Terry in Winnipeg.

--
Message posted via http://www.carkb.com

loewent via CarKB.com wrote:
<snip chit-chat>
> The t-belt seemed to have good tension, but the balance shaft belt was (i
> thought) a little loose.

the process that you used for the timing belt, you use for the balance
shaft belt.