Honda Car Forum |
|
|
|||
|
I have a 1991 CRX w/1.5L dual-port engine. Just put in a new block. Haven't
been able to get it to start. Keep getting a code 16 (injector code). Checked the resistance on the injectors like the book says. They check out OK. Even tried putting in a couple of other ones that I had. Still get the code. Checked the main relay, it's OK also. Anybody got any ideas? Thanks. |
|
|||
|
DD wrote:
> I have a 1991 CRX w/1.5L dual-port engine. Just put in a new block. Haven't > been able to get it to start. Keep getting a code 16 (injector code). > Checked the resistance on the injectors like the book says. They check out > OK. Even tried putting in a couple of other ones that I had. Still get the > code. Checked the main relay, it's OK also. Anybody got any ideas? Thanks. it /is/ the main relay. unfortunately, it's an intermittent fault, so just because you tested it a couple of times and it shows ok, doesn't mean it's not the fault. pull the relay and either resolder or replace. go to tegger.com and check out his section on relay repair & replacement. |
|
|||
|
Thanks for the help. It wasn't the relay. I went to tegger.com to research
it like you said. It was a stupid ground wire near the thermostat that comes from the ecu that didn't get attached. Hooked it up and it cranked immediately. Sure would have been nice to know a week ago. But better late than never. "jim beam" <nospam@example.net> wrote in message news:PdudnQ2xBMFystTeRVn-jQ@speakeasy.net... > DD wrote: >> I have a 1991 CRX w/1.5L dual-port engine. Just put in a new block. >> Haven't been able to get it to start. Keep getting a code 16 (injector >> code). Checked the resistance on the injectors like the book says. They >> check out OK. Even tried putting in a couple of other ones that I had. >> Still get the code. Checked the main relay, it's OK also. Anybody got any >> ideas? Thanks. > > it /is/ the main relay. unfortunately, it's an intermittent fault, so > just because you tested it a couple of times and it shows ok, doesn't mean > it's not the fault. pull the relay and either resolder or replace. go to > tegger.com and check out his section on relay repair & replacement. > |
|
|||
|
DD wrote:
> Thanks for the help. It wasn't the relay. I went to tegger.com to research > it like you said. It was a stupid ground wire near the thermostat that comes > from the ecu that didn't get attached. Hooked it up and it cranked > immediately. Sure would have been nice to know a week ago. But better late > than never. ok, glad you got it fixed! gotta say, tegger's diagnostics on that relay thing are /way/ better than any manual! > > > > "jim beam" <nospam@example.net> wrote in message > news:PdudnQ2xBMFystTeRVn-jQ@speakeasy.net... > >>DD wrote: >> >>>I have a 1991 CRX w/1.5L dual-port engine. Just put in a new block. >>>Haven't been able to get it to start. Keep getting a code 16 (injector >>>code). Checked the resistance on the injectors like the book says. They >>>check out OK. Even tried putting in a couple of other ones that I had. >>>Still get the code. Checked the main relay, it's OK also. Anybody got any >>>ideas? Thanks. >> >>it /is/ the main relay. unfortunately, it's an intermittent fault, so >>just because you tested it a couple of times and it shows ok, doesn't mean >>it's not the fault. pull the relay and either resolder or replace. go to >>tegger.com and check out his section on relay repair & replacement. >> > > > |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fuel injector cleaners | fullness | Honda 2 | 7 | 18 Jun 2005 04:18 pm |
| fuel injector cleaning? | Chris G. | Honda 2 | 5 | 29 Nov 2004 04:47 am |
| fuel injector cleaners | RanMan | Honda 3 | 9 | 18 Nov 2003 10:40 pm |
| Fuel Injector Cleaners | Steve Lee | Acura | 9 | 15 Aug 2003 01:42 pm |
| Fuel Injector Cleaners | Steve Lee | Honda 3 | 5 | 24 Jul 2003 04:47 pm |