Honda Car Forum

Can the "Bushing Extractor for Honda & Acura" that
seems to be all over the Internet (for example,
shoptoolsshoptools.com/shopexd.asp?id=2784) be used to
remove the remove the rear trailing arm bushings from
a *1991* Acura Integra?

Thanks.

-----------
Brian E. Clark

Brian E. Clark wrote:
> Can the "Bushing Extractor for Honda & Acura" that
> seems to be all over the Internet (for example,
> shoptoolsshoptools.com/shopexd.asp?id=2784) be used to
> remove the remove the rear trailing arm bushings from
> a *1991* Acura Integra?
>
> Thanks.
>
> -----------
> Brian E. Clark

======================

check www.tegger.com for that answer.

'Curly'

motsco_ <motsco_@interbaun.com> wrote in news:13u4sbis6es46f3
@corp.supernews.com:

> Brian E. Clark wrote:
>> Can the "Bushing Extractor for Honda & Acura" that
>> seems to be all over the Internet (for example,
>> shoptoolsshoptools.com/shopexd.asp?id=2784) be used to
>> remove the remove the rear trailing arm bushings from
>> a *1991* Acura Integra?
>>
>> Thanks.
>>
>> -----------
>> Brian E. Clark
>
> ======================
>
> check www.tegger.com for that answer.
>
> 'Curly'
>



There is actually no answer for that on my site.

I suspect that tool is for the Civic's bushing, which is smaller than the
Integra's.

In any case, the Integra always came with rear discs, so you don't have to
break open the hydraulics to remove the trailing arm. You can therefore
remove the arm and have a garage press the old bushing out and the new one
in.

If the OP's new bushing part number is 52385-SK7-N02, then chances are
pretty good the Civic tool won't fit.



--
Tegger

The Unofficial Honda/Acura FAQ
www.tegger.com/hondafaq/