Honda Car Forum

hi
My car is Acura model Integra and year 1999
I got a leakage in the upper portion of the radiator. commonly th
plastic part between the aliminium stuff and cap portion.It is actuall
a hair pin leak in the joint part of plastic t
plastic. I applied a cold weld there but no result. An
suggestions???
if i had to replace the rediator instruct me hoe to do it manually
thank
Manmee
I know! i had a crack on the top tank on my 92 prelude SR radiater unfortanatley the
original ones are made of some kind of plastic composet theres no quick fix for repairing it i settled for an aftermarket 4seasons rad $200 cash.

1st. place the front end on 2- 1/2 Ton jack stands next disconect - negative cabl
have a large container near by. unclamp the bottom rad hose pull it off the radiater splash" out comes the coolant take off the top hose on rad
next take off coollant resevoir clean it out good fill to max put back next disconnect cooling fan wires apart lift up the radiater transfer your cooling fan(s) from

your old rad to your new one slide back down your new one in place. connect your upper and lower rad hoses plug back in your cooling fan wires go over to battery and tighten down the -negative cable slide your heater control to heat start your engine and fill rad with a premixed 50/50 antifreeze mix let idle next open up the bleeder screw and bleed it top off rad and enjoy! ;

--
johnin

-----------------------------------------------------------------------
View this thread: http://www.carstalk.net/viewtopic-424589.htm

Send from http://www.carstalk.ne