Honda Car Forum

cmr1064 · #1 (**permalink**) 11 Jul 2009, 01:01 am

so i just added the intake from original stock one and now i have an issue. if i am driving and i start getting on it hard (i drive fast) and then stop and park with the car off. i cannot start it back up with out it sputtering then stalling and its an automatic. it will start up again if i wait for a while, about ten minutes. Whats Wrong and What could I Do???

john m · #2 (**permalink**) 11 Jul 2009, 01:16 am

the intake should not of have anything to do with the problem that you have...the only thing that i could think of is that you probably knocked a sensor off some where or you got a faulty/dirty maf sensor...

Headlessmunky · #3 (**permalink**) 11 Jul 2009, 01:31 am

Actually honda Uses Map Sensors. Not MAF's. Check all sensors around it. Make sure all connections are tight. do you let it run for a sec before you shut it off. Could be Afr off causing this. Also try resetting your ecu. Unplug the ECU fuse its on the Passenger side near the Intake manifold. Its a 15 amp fuse i believe it blue. Sounds did you make sure your vacuum hose was tight? Sounds like a Vac leak

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Do you think 95 Acura Integra LS stock intake will fit on a 95 Acura Integra GSR? ?	JeffyLube	Acura Technical	5	08 Nov 2008 08:01 pm
'99 Acura Integra... cold intake question?	reggie	Acura Technical	3	03 Oct 2008 01:16 pm
How Much HP do i get from my new K&N short ram intake on my 90 Acura Integra?	hamfacekilla	Acura Technical	3	15 Sep 2008 10:01 am
B series Intake Manifold? Acura Integra?	Karen A	Acura Technical	3	31 Aug 2008 12:01 pm
Acura Integra GS Auto and Cold Air Intake V2?	Rachemon	Acura	4	09 Jun 2005 10:05 pm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)