Honda Car Forum |
|
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
|
|||
![]()
i might buy an integra that is bored over .020,,what does that mean? Good or Bad? thanksheres the listing---Up for sale is my Integrs GSR body has just over 84,000 New built engine has around 25k loads of mods... jasma poweshot duals -800$ JDM Front clip-1500$ Kaminari sideskirts-450$ Green cold air intake-125$ Gauges 90$ AEM fuel rail 250$ Skunk2 shortshifter100$ bored over .020 eagle rods JE pistons ported and polished heads JDM lightened flywheel r1 racing rims-650$ racing suspension'new hid headlight conversion 130$ will trade car and money for s2000 350z subaru sti or evo stage 3 cams
|
|
|||
![]()
Bored .020 over means that the cylinders have been bored 20,000's of a inch bigger, which will give you a little more power out of the motor. Also, don't bore a motor more than .040 over or you'll start having problems with the motor, and most likely ruin the block, because the cooling passages going through the block have a risk of cracking, because the space between the cylinder and the water passages get smaller when bored. Basically .020 is OK, just don't go over .040.
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
wat r some good springs for an integra? | Jesse H | Acura Technical | 7 | 21 Sep 2008 01:01 am |
is integra a good car in the way of upkeep and reliability? | agnotheist | Acura Technical | 4 | 09 Jul 2008 08:52 pm |
Who wants to buy a 1993 honda civic hb with b18 engine swap bored out to a 2.0? | Brandon B | Honda Technical | 4 | 04 Sep 2007 09:36 am |
What mods would be good for a 95 Integra GSR? | Andrew J | Acura Technical | 9 | 27 Aug 2007 04:04 pm |