Honda Car Forum

A.I. · #1 (**permalink**) 07 Jan 2009, 03:01 pm

i need to change this immediatley and im not sure how to do it and i feel i should do it myself please help??.... how do i do this and is it easy

mike d · #2 (**permalink**) 07 Jan 2009, 03:16 pm

unless you know what your doing you shouldn't mess with it but heres the step by step...http://www.autozone.com/az/cds/en_us...es.htm#topgood luckor On your 1988 Acura Integra 1.6L FI , the Control Module-Ignition is located: Under hood, passenger side, upper engine area, end of intake manifold, mounted on distributor

Jesus R · #3 (**permalink**) 07 Jan 2009, 03:31 pm

ignition module? or igniterif you change that, change the coil also.if you don't the coil will go out very soon.take the dizzy cap off, take out the rotor. and there you go.take some screws out and place the igniter and coil back in place.do it one at a time.not very hard, if your worried about it take a pic before you take it apart

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what are symptoms of a bad distributor assy for 1988 acura integra?	A.I.	Acura Technical	2	07 Jan 2009 03:16 pm
How to replace distributor in 99 Honda CR-V?	Steveo	Honda 3	12	11 Dec 2006 01:43 pm
Replace the coil or the whole distributor?	hutchtoo	Honda 2	9	03 Sep 2005 09:08 pm
Distributor Bolts / Ignition Timing - '91 Civic Si	Chopface	Honda 3	35	17 Jul 2004 10:55 pm
Acura Integra's accessory	Peter	Acura	2	16 Feb 2004 04:03 am

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)