Honda Car Forum

glenn s · #1 (**permalink**) 30 Jul 2008, 05:31 pm

i bought a 94 integra gs with a full gsr swap but the motor is blown. hole in block, do i have to use a gsr botton r can i use the GS are LS bottom or may be something else

Azn Street racer · #2 (**permalink**) 30 Jul 2008, 05:46 pm

the gsr block has oil sqirters... , but the head wont fit onto a LS block without haveing work done to it.. i would go into detail but im too tired rite now =[checkout this site though team-integra.net

Chris · #3 (**permalink**) 30 Jul 2008, 06:01 pm

LS and Gs have a better stroke and lower compression .. in order to put you have to drill and tap the head for the oil to pass through to activate the vtec because it is started by a pressure sensor ...HONDA-TECH.comyes ,, ls and gs do not have oil squirters so there is less rotating mass on the crank shaft

ViperKilla · #4 (**permalink**) 30 Jul 2008, 06:16 pm

LS/RS/GS/SE are B18B's bottom end, lower comp, same displacement, you need to top the block, and ever heard of LS/Vtec that is what you have dont liston to AZN-integra site sucks. Honda-tech.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
So what is the difference between honda and acura integra?	warcraftgod101	Acura Technical	4	02 Jun 2008 12:16 am
How do you tell the difference between a 94 acura integra rs, gs, and the gsr?	jakeleasure	Acura Technical	6	02 Dec 2007 11:31 pm
what is the difference between acura integra and acura integra type r?	kolin v	Acura Technical	6	25 Aug 2007 03:28 am
Re: Acura Integra difference in VTEC and not	Jim Yanik	Acura	2	23 May 2005 08:13 pm
Acura Integra difference in VTEC and not	Rachemon	Acura	0	15 May 2005 09:37 am

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)