Honda Car Forum

Changa Pachanga · #1 (**permalink**) 01 Nov 2007, 10:42 am

help?

25 years experience! # 2!!!!!!!! · #2 (**permalink**) 01 Nov 2007, 10:45 am

You need a special tool, shaped like the big center section of the pulley. You hold that tool and then you can loosen the main bolt with a 1/2 drive breaker bar.They are VERY TIGHT, you cannot get it with your average impact gun. Either get the tool, beg borrow,,rent ,steal or get a 3/4" impact gun with lots of air to drive it. (read that as a COMMERCIAL air compressor, not some home garage small tank thing)

tronary · #3 (**permalink**) 01 Nov 2007, 10:48 am

If you can go to Auto Zone parts store and buy your parts there they will loan you the proper tools and give some advice.

Lady Hua · #4 (**permalink**) 01 Nov 2007, 10:51 am

you need to wedge a screw driver in the crank wheel (on the other side of engine, i think it's called that) and find yourself a nice breaker bar... a long ass centerless bar you can stick your socket or torque wrench in, and start loosening that baby!!!! use a nice impact wrench!!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Crank & Crank Pulley Problems in 97 1.6EL	tada	Acura	0	16 Jun 2004 05:31 am
Crank & Crank Pulley Problems in 97 1.6EL	tada	Honda 2	0	16 Jun 2004 05:31 am
Timming belt	Andy & Carol	Honda 3	2	10 Feb 2004 09:57 am
93 integra 1.8L - Crank pulley bolt won't come loose?????	Bill Abbott	Acura	1	04 Nov 2003 06:02 am
NEED a CRANK pulley 92-95 Civic EX D16Z6	dimmi	Honda 3	4	11 Oct 2003 06:32 pm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)