Honda Car Forum

i have a 1997 acura integra rs non vtec and i want to put in a motor that can handle high rpms (8k-10k) (vtec) and handle the boost psi of a turbo running 6-8 psi of boost (lower compression) and i was also wondering what i would need to make the motors you list run in my car (ecu, wiring, axles, ect.)

Any 1994 - 2000 integra motor will fit easily. Motors from Civics of those same years will probably fit too, but will require more work.You'll need the VTEC wiring harness from the donor car.WARNING: Adding a turbo to a high mileage motor will likely cause it to burn oil. Try to get a motor with less than 50k miles on it.

Any honda motor fwd will fit into a acura but if you want high reving and can handle boost get a h22 or an k20 if you have the funds get the k20 just your basic boltons your looking at a 13 sec car.

you can put any motor in there that you want k, b, h, f, franks, ls/vtec....anything you want. as of high rpms 8-10k on boost....your asking for serious trouble. your going to have to actually build the motor to handle that kind of stress and even then it is high doubted that you will do this. you want information (complete motor swaps possible and instructions on what to do) email me at my address listed below.

just about any motor will fit into that car... i dont know if this will go to 8k-10khttp://www.tunerzimage.com/B16a-DOHC...p/e-m-b16a.htm

B18C3 (us type R motor) 95-98B18C5 (US type r motor) 98+B16A Si motor (00)B17 (93 gsr motor)