Honda Car Forum

gonzalez.norberto@sbcglobal.net · #1 (**permalink**) 15 Aug 2007, 07:23 pm

how can I change the transmition oil in a 1991 acura integra?

jay is mad at me · #2 (**permalink**) 15 Aug 2007, 07:25 pm

Auto trans? Need about 3 qts Honda ATF Z-1, and a crush washer part# 90471-PX4-000. Drain and fill, very easy.

sorrells316 · #3 (**permalink**) 15 Aug 2007, 07:31 pm

automatics,take bolts loose on pan, loosen them enough to drain fluid, then remove bolts to drop pan and clean with a clean rag, install pan with new gasket or silicone, fill with appropriate fluid through check tube, check manual or parts store to see how much fluid is needed, without emptying torque converter. if manual transmission, should be a drain and fill plug on drivers side of tranny. this type usually does not need replaced.

nbaggio10 · #4 (**permalink**) 15 Aug 2007, 07:35 pm

the honda atf z-1 fluid part number is 08200-9001

nuginata · #5 (**permalink**) 15 Aug 2007, 07:49 pm

sorrells316 is wrong. They don't have a tranny pan. Just a drain plug on the side. No filter to replace,just drain and add 3 qts. of tranny fluid,drive and check the tranny dipstick with engine off.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1991 Acura Integra	AnthonyD	Acura	4	10 Jan 2006 08:55 am
My 1991 Acura Integra LS won’t start	jaydog5000	Acura	4	15 May 2005 11:47 pm
Re: How much HP on 1991 Acura Integra GS??	o. phooey	Honda 3	0	03 Jan 2005 11:31 am
1991 Acura Integra GX ABS Problem	S Ramirez	Acura	7	28 Dec 2003 12:19 am
FS: Acura Integra 1991	Amar Minhas	Acura	0	09 Aug 2003 02:44 pm

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)