On 8/27/04 6:59 PM, in article
e5ccbd66.0408271559.94a4091@posting.google.com, "Jingyuan" <zhangaj@aol.com>
wrote:

> Hello, everyone,
>
> Today I just have my both CV axles replaced by a local shop (listed as
> Axle Specialist on the phone book). A pickle fork was used to separate
> the ball joints. Unfortunately, as a result, the right balljoint dust
> boot is split and the left one is damaged. My questions to you are
>
> 1. Is it ok to leave it split?
> 2. If not, can I just replace the dust boot or the whole ball joint
> needs to be repalced?
>
> The shop rebuilt the axles by themseves. They reused spindle nuts on
> my car, which were partially broken when unstaking them, but they
> staked at another position.
> 3. Is this practice acceptable?
>
> I am not sure if they reused the spring clips at the inner ends.
>
> Your response is greatly appreciated, and my car is 92 accord DX auto.
>
> Jingyuan

Sounds like a real top notch place... (not)

NAPA has replacement boots in various sizes. They might have the size you
need. If the joints themselves are still good, you could try that route.
Otherwise, you'll have to replace the joints.