Arthur, yes...the engine light had been on (O2 Sensor) prior to the trans
failure. I am not sure what you mean by "reading codes out of the
transmission (it flashes D4 light I think)". Please advise...

Thanks,

Mike



"Arthur Russell" <atr@REMOVE_CAPS_AND_INVALIDbellatlantic.netINVALI D> wrote
in message news:gHXnc.45428$wY.44230@nwrdny03.gnilink.net...
> You didn't mention (in your earlier post) that the check engine light was
> on. If it wasn't on already, then when you short the 2-P connector, it
will
> only light up (to show you that it *can* blink) and will not flash out
codes.
>
> Was the engine light on in the first place? Also, have you tried reading
> codes out of the transmission (it flashes D4 light I think)
>
> -Arthur
>
> Mike Vaughn wrote:
>
> > Well, a fluid change did nothing to get the transmission to work, but I
did
> > notice something strange in doing some troubleshooting...in trying to
> > retrieve the trouble codes for the "engine" light, I would not get any
> > flashing of the engine light after shorting the connector pin. Does
this
> > provide a clue to something I am missing?
> >
> > Thanks,
> >
> > Mike
> >
> >