You didn't mention (in your earlier post) that the check engine light was
on. If it wasn't on already, then when you short the 2-P connector, it will
only light up (to show you that it *can* blink) and will not flash out codes.

Was the engine light on in the first place? Also, have you tried reading
codes out of the transmission (it flashes D4 light I think)

-Arthur

Mike Vaughn wrote:

> Well, a fluid change did nothing to get the transmission to work, but I did
> notice something strange in doing some troubleshooting...in trying to
> retrieve the trouble codes for the "engine" light, I would not get any
> flashing of the engine light after shorting the connector pin. Does this
> provide a clue to something I am missing?
>
> Thanks,
>
> Mike
>
>