View Single Post
  #5 (permalink)  
Old 20 Feb 2004, 06:06 am
Mista Bone
Guest
 
Posts: n/a
Default Re: Broke hood cable lever

You replace the whole assembly.

The new part from Honda includes the pull lever, cable, and firewall
grommet.
it was about $23 from www.slhonda.com

"Caroline" <caroline10027remove@earthlink.net> wrote in message
news:nA7Zb.398$aT1.174@newsread1.news.pas.earthlin k.net...
> Mista,
>
> My hood release cable became "overstretched" years ago. The result is the

hood
> release lever doesn't extend it far enough to pop the hood. The hood

release
> lever itself is not broken. I open the hood using pliers to grasp the end

of the
> cable and pulling. It's not difficult, but it's also not convenient.
>
> Can I get in there following your directions and replace the hood release

cable
> in its entirety?
>
> I've had the front hood release mechanism apart (for cleaning) but at the

time
> wasn't sure I could easily thread a new hood release cable into place for

the
> whole length.
>
> I guess the alternative is to figure out how to move the metal stopper on

the
> end of the cable so the distance is correct.
>
> "Mista Bone" <mistab0ne@nospam.net> wrote
> > Just did it this weekend on my 93 Civic.
> >
> > Jack up car (use stands!) and remove LF wheel.
> >
> > Remove front bumper and LF inner fender liner. Unhook the cable from the
> > outside latch, then unbolt the the inside pull. The rest is pretty

simple.
> > It took me about 30 minutes, but my front bumper was already off from a
> > wreck.
> >
> > A dealership mechanic should be able to get it done in about 1-1.2

hours.
> >
> >
> > "sat" <satadalb@yahoo.com> wrote in message
> > news:d72c00feebb1787f255cec7f9fff4315@localhost.ta lkaboutautos.com...
> > > Hi,
> > >
> > > The plastic lever (which you pull to open the hood) on my 1997 Honda

Civic
> > is broken. The cable is fine though. I have to pull the broken lever

with a
> > plier or tongs to get the hood open. The dealer is aksing 2 hrs of labor

to
> > replace it. The part is under $20. Can anybody please let me know

whether it
> > is possible to do it by self? If so how to get it done?
> > > Thanks,
> > > Sat
> > >

> >
> >

>
>



Reply With Quote