View Single Post
  #3 (permalink)  
Old 27 Jan 2004, 08:47 pm
Tegger®
Guest
 
Posts: n/a
Default Re: Winshield washers

"'Curly Q. Links'" <motsco__@interbaun.com> spake unto the masses in
news:40171596.4010909@interbaun.com:

> Ric wrote:
>
>> What I originally said was, I have an 03 Accord sedan. Is it
>> possible to adjust the spray of the windshield washer? I don't know
>> what happened but my driver's side is aimed too low. If adjustment
>> is an easy thing I might try it myself rather than take it to the
>> dealer.
>>
>> Thanks

>
> ==================
>
> Ric,
>
> Ususlly the nozzle is just a steel bearing with a hole drilled thru
> it, and it swivels in the plastic mount. Put a large pin into the
> hole, then swivel it up a few degrees. You might dislodge some crud
> while you're poking around in ther, but not likely on an '03.



The newer ones seem to have a non-adjustable sprayer nozzle with at least
two streams. Perhaps the upper one of the two has become blocked on the
OP's car. A needle or brush bristle poked through the hole while spraying
may cure the blockage.

--
TeGGeR®
Reply With Quote