Some recommendations on disabling the air bag include disconnecting the
battery and removing SRS fuses and letting it sit for 10-15 minutes before
proceeding. I don't know if it is actually necessary but when you are going
to be working next to an explosive device a little extra precaution doesn't
hurt.


"Alan" <twobutnot2@comcast.net> wrote in message
news:1151732488.846062.239700@j8g2000cwa.googlegro ups.com...
>
> || wrote:
>> I have a 1993 Honda Civic DX two door. I need to replace the light
>> switch located in the steering wheel column. I am doing this because
>> the tail light won't turn off and I checked all the fuses and am left
>> with this as the problem. This car has an airbag. I would like to
>> know if I have to remove the steering wheel and if so do I need any
>> special tools? Is this a difficult task and is my assessment correct?
>> Is their a website with any information on how to do this?
>
> http://www.autozone.com/servlet/UiBr...3d80141de3.jsp
>
> Courtesy of Autozon
> Repair Guide.
>
> 1992-95 Models
>
> WARNING
> All SRS wire harnesses are covered with a yellow insulation. Read the
> SRS precautions found in this section and install the short connectors
> as described.
>
>
>
> 1. Disconnect the negative battery cable and disable the SRS system.
>
> 2. Remove the upper and lower steering column covers.
>
> 3. Disconnect the 4-pin and 7-pin connectors from the switch.
>
> 4. Remove the switch retaining screws and slide the switch from its
> mount.
>
> To install:
>
> 5. Install the new switch in position and connect the electrical leads.
>
> 6. Install the upper and lower steering column covers.
>
> 7. Disconnect the short connectors and connect the negative and
> positive battery cable.
>