1bolt_atatime wrote:
>
> Hi,
> I am replacing a cv axle on a 92 accord.
> I got the old one out w/o problems, but I just cannot seem to manage to
>
> lock the new one back into the tranny. The splined end goes in 1/2 way
> and then seems to hit on something and not move any further. Is it a
> matter of pure "force" or is there some "trick" to get it into the
> tranny? Is a hammer necessary?
>

Don't use a hammer! Instead, put the inner joint into the transmission and
then put the outer joint into the hub but DON'T reconnect the ball joint.
Next, grab the brake roter/hub assembly and use it to push the axle in such
that the clip ring on the inner joint is seated. It usually just takes a
light to moderate amount of force swinging the brake rotor/hub assembly
inwards. You should be able to feel the inner joint pop into place.
Visually inspect the installation to make sure that it's seated correctly
and then reassemble the ball joint and anything else you may have
disassembled.

Eric