"hondabrokenalldetime" <mrmitchpeters@yahoo.com> wrote in message news:1132199656.683230.228420@z14g2000cwz.googlegr oups.com...

> Ok like every other joker that works on his car I've tried to trace
> down every single problem I thought possible, so here goes. I have no
> ignition spark, but I've already replaced the main relay and the entire
> distributor assembly, and just to make sure that the new assembly was
> right i tested everything that I tested on the old one, ignition coil
> checks good, ignitor unit checks good , timing belt is in tact and
> spinning, rotor seems to be spinning properly, but nothing no spark, I
> replaced the distributor assembly because I read about the TDC (Top
> Dead Center) sensor and the CKP (Crankshaft Position Sensor were all
> apart of the distributor assembly, and not testable, so here i am stuck
> any suggestions?

Usually there are two places to check for sparks. One at the end of
the plug wire, the other at the secondary port at the coil. The "check
engine light" goes on then off?