Heres the update, I checked it out today, see when i pulled it out the fuel
sending unit was dangling from the pump, well i thought it was normal
therefore i put it bac kthe same way, well the float got caught up on the
sock filter, well i attached the unit to the pump then hooked up ohm meter,
was reading resistenace, and reinstalled it, I will repost later if anymore
problems, I filled the tank all the way up, I will see at half if its
acuarate ornot , again THANKYOU guys for the help.

"Shawn Taylor" <accordpower99@cox.net> wrote in message
news:zt1ve.18215$FP2.12837@lakeread03...
> I have a 99 honda accord ex coupe, I recently had takin out my
fuelpump/fuel
> sendin unit assembly. The probelm is when i put it back in and started my
> car up the fuel gauge started going up to about 3/4 full. but i actually
had
> less than a 1/4 tank, well i finally went back down but still seemed
alittle
> high. So i had taken out the pmump again checked the sendin unit and
nothin
> seems to be blocking the arm or anything. Well i filled my tank up and the
> needle went up lioke normal but i have been driving around and the needle
> has droped down alittle like normal, BUT just now the needle just maxed
> out. Heres some ?'s I have.
> 1. When you turn the car off is the needle suppose to fall to empty until
> you give your car power?
> 2. If not, I had the connector that plugs to the pump off, and had then
neg
> cable off, the needle stayed at like 1/4 tank, before i filled it back up.
> Was that normal?
> 3. want kinda of test do i need to do to figure this out?
> Thankyou for your help.
>
>