Try your local library or short the fuse and watch for smoke. Did you unplug
the fan to see if it is shorted?


"halo2 guy" <somewhereovethe@rainbow.com> wrote in message
news:EZydnbvXP-Mch7vfRVn-rA@comcast.com...
> well in my factory electrical 1996 accord manual the number 9 fuse is
> under the dash/ as opposed to under the hood and it is listed as 7.5 amp
> fuse it is called the starter signal fuse which protects the "guage
> assembly, pgm-fi main relay, powertrain or engine control module (pcm or
> ECM)"
>
>
>
>
>
>
>
> <dispman2000@yahoo.com> wrote in message
> news:ih4c21pbu4psg9dr9v8gfhrebn86us4hab@4ax.com...
>> The problem started with the battery going dead. Put on new battery
>> and the battery drained overnight. Found that something was drawing a
>> lot of current with everything turned off using a test light. Checked
>> between the pos and neg cables and was reading 0 ohms pulled the #9
>> 15 amp fuse and the short went away. Left battery cables on with #9
>> fuse out overnight and the battery stayed charged overnight. Just need
>> to know what this fuse feeds so I can trace down where the problem is.
>>
>> Thanks for your help.
>>
>>
>>
>> On Wed, 2 Mar 2005 09:37:15 -0800, "halo2 guy"
>> <somewhereovethe@rainbow.com> wrote:
>>
>>>You need a factory schematic manual. I happen to have one for the 96
>>>Accord
>>>but I have no way of scanning it or really relaying the information to
>>>you.
>>>
>>>I am sure somebody in here can scan a few pages for you.
>>>
>>>I would look at the fues rating to see if it is indeed the correct fuse,
>>>not that it would matter if indeed you have a short to ground. I am also
>>>curios how you determined you have a short to ground as opposed to a just
>>>a
>>>high amp load?
>>>
>>>
>>><dispman2000@yahoo.com> wrote in message
>>>news:8qhb21l17jig4h1vm0l74rbs2vl2i2rjbf@4ax.com ...
>>>>I am looking for a wiring diagram for a 1996 Honda Accord DX. I have a
>>>> 12 volt short to ground at fuse 9 that goes to the condenser fan. My
>>>> Hane's manual does not show the wiring diagram for this circuit.
>>>>
>>>> Any help will be much appreciated.
>>>
>>
>
>