Hey,

1991 Civic LX 1.5 Liter DPFI here.

I replaced the ignitor (a.k.a. "ignition module") last year. Got into a big
discussion about how it works and some of the wiring. I googled and came upon
the sites below.

http://www.markl.f9.co.uk/howto/elec...er/igniter.htm (has a drawing,
but probably not nearly as good as that in the next site)

Try especially the link in blue titled "download this zip" at
http://www.gcw.org.uk/rover/igniter.htm . Before you start downloading, notice
also there is a verbal description of the wiring.

If the link fails, email me, as I think I still have the drawing and might be
able to talk you through it.

"Jonathan Upright" <qaesar1@hotmail.com> wrote
> OK, I just did something very, very stupid. While changing my igniter, I
> didn't mark the wires as to which wire goes to which terminal. I only know
> for sure where one of the four wires goes. Can someone either tell me (or
> point me to a website) how the wiring is supposed to be? I only have a
> Haynes manual, and it doesn't give any wiring diagrams. Any help would be
> MUCH appreciated.
>
> Thanx! :-)
>
> Jonathan
>
> P.S. In case you're just joining us, my car is a 1990 Honda Civic LX, 1.5L
> DPFI