In article <Xns9CB3C8962DADtegger@208.90.168.18>,
Tegger <invalid@invalid.inv> wrote:

> Face <face@yahoo.com> wrote in news:face-0CE14C.17294829102009
> @newsfarm.iad.highwinds-media.com:
>
>
> >
> > The thermo unit (what the package says) is in and the gauge is working
> > good. Whew!
>
>
> Success is always nice.
>
>
> >
> > Will do the coolant change this weekend. No time today, beggars night
> > and all that. I had the dealer install an engine block heater and I
> > believe it is located in the block drain hole. Do you happen to know if
> > I need to put any kind of thread sealant on the heater before I put it
> > back in.
>
>
>
> I use one turn of Teflon plumber's tape, wrapped such that it will not
> unwind when I screw the drain bolt back in.

That'll work. I always have some teflon tape laying around.

Thanks again for the advice.