data D <datadr77@hotmail.com> wrote in
news:llj9e5tj6u9orhh9en891e2ie21a8lau6l@4ax.com:

> Cheers,
>
> Turned the pistons into the calipers...
> No didn't remove the parking brake cables
>
> dd77
>
>
>
> On Sun, 25 Oct 2009 14:42:34 +0000 (UTC), Tegger <invalid@invalid.inv>
> wrote:
>
>>data D <datadr77@hotmail.com> wrote in
>>news:bpl8e556lc0skd0fs18njf7215o36bfg6k@4ax.co m:
>>
>>> Cheers,
>>>
>>> I replaced the disc pads on my 2006 Honda Civic.
>>>
>>> The brakes are working just fine... HOWEVER...
>>> Now my Emergency Brake is not working...
>>> There is NO tension on the hand lever.
>>>
>>> Andy Ideas?
>>> or where I can find out how to adjust
>>> Thanks in Advance
>>>
>>> Data Dr77
>>>
>>
>>
>>1) How did you get the pistons to go back in? Pushing or turning?
>>
>>2) Did you disconnect the parking brake cables from the caliper?
>

My Civic/Integra manual(94-00) shows an adjusting nut on the single short
cable coming from the handbrake arm,located underneath the center
console.the single cable pulls on a bar("equalizer") that pulls on the two
cables to the rear brakes.

the manual says you have to remove the center console to access this nut.

you might try investing in a Haynes manual for your specific model,or spend
more and get the factory Honda manual,or a Helms manual.

--
Jim Yanik
jyanik
at
localnet
dot com