Woody wrote:
>
> If you wait a while it will probably reset itself if there are no faults.
> Most reset after a few drive cycles...
>
> "self reg test 12" <cbwucvuwbu@cox.net> wrote in message
> news:s9z1c.27902$qL1.21743@fed1read02...
> > jim wrote:
> > > self reg test 12 wrote:
> > >>
> > >> I removed the passenger seat to haul some long tables and after
> > >> reinstalling and reconnecting all of the wiring, the SRS light stays
> > >> lit on the dash. Is there a reset switch or button?
> > >>
> > >> --
> > >>
> > >> Chris
> > > hey check out this, found it on the www.yahoo.com and did a search
> > > on SRS light, honda and came up with this... hope it helps... i have
> > > the same problem with a 2001 civic and got alot of sites with info on
> > > how to reset it... the best one is on www.superhonda.com where it
> > > shows you the pictures, i could not locat the thing under my dash,
> > > kinda old and could not bend that far down to get under there(bad
> > > back) oh well will get some kid to climb under there and check it out
> > > of me... http://www.honda-tech.com/zerothread?id=264288
> >
> > --
> >
> > Thanks, Jim. This looks like a winner. Pasting for others to use:
> >
> >
> > Directions for erasing memory on SRS light
> > 1st you need to either buy or make the "SCS Service Connector." I used a
> > speaker harness for and older Honda which you can buy at a local stereo
> shop
> > such as Circuit City or Best Buy, and cut the wires and looped them
> > together. You can also use a paperclip but that will make it a little more
> > difficult because you have to connect it and disconnect it a few times
> > quickly.
> > 2nd you need to find the MES (Memory Erase Signal) connector
> >
> > MES Plug in Fuse box. It is a yellow connector with two wires in it that
> is
> > plugged into the fuse box, unplug it and pull it down. Once you have done
> > that you can begin the process of erasing the memory. NOTE: This will only
> > reset your SRS System if what caused it to trigger has been fixed, Ex:
> > turning the ignition on with any SRS Plugs disconnected, such as pulling
> > your seat out.
> >
> > 1st step in erasing the memory is to turn the ignition off and connect the
> > SCS Service connector to the MES Plug,
> >
> > 2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds
> > then go off.
> >
> > 3rd Disconnect SCS service connector for MES connector within 4 seconds
> > after SRS indicator light goes off. SRS indicator light will come on
> again.
> >
> > 4th Reconnect SCS service connector the MES connector within 4 seconds
> after
> > SRS light comes on. SRS indicator light will go off.
> >
> > 5th Disconnect SCS service connector from MES connector within 4 seconds.
> > SRS indicator light will indicate that memory is erased by blinking 2
> times.
> >
> > 6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and
> > light should come on and go out like normal. You have reset your SRS
> light,
> > congrats.
> >
> > If it does not work the first time try it again, the timing has to be
> > perfect. My first time it took me 3 attempts before it worked, but it did
> > work.
> >
> >
gee the info i received from the honda dealer and from the internet is
that you have to reset it to get the light to go out... unless the bulb
burns out....