If you wait a while it will probably reset itself if there are no faults.
Most reset after a few drive cycles...


"self reg test 12" <cbwucvuwbu@cox.net> wrote in message
news:s9z1c.27902$qL1.21743@fed1read02...
> jim wrote:
> > self reg test 12 wrote:
> >>
> >> I removed the passenger seat to haul some long tables and after
> >> reinstalling and reconnecting all of the wiring, the SRS light stays
> >> lit on the dash. Is there a reset switch or button?
> >>
> >> --
> >>
> >> Chris
> > hey check out this, found it on the www.yahoo.com and did a search
> > on SRS light, honda and came up with this... hope it helps... i have
> > the same problem with a 2001 civic and got alot of sites with info on
> > how to reset it... the best one is on www.superhonda.com where it
> > shows you the pictures, i could not locat the thing under my dash,
> > kinda old and could not bend that far down to get under there(bad
> > back) oh well will get some kid to climb under there and check it out
> > of me... http://www.honda-tech.com/zerothread?id=264288
>
> --
>
> Thanks, Jim. This looks like a winner. Pasting for others to use:
>
>
> Directions for erasing memory on SRS light
> 1st you need to either buy or make the "SCS Service Connector." I used a
> speaker harness for and older Honda which you can buy at a local stereo
shop
> such as Circuit City or Best Buy, and cut the wires and looped them
> together. You can also use a paperclip but that will make it a little more
> difficult because you have to connect it and disconnect it a few times
> quickly.
> 2nd you need to find the MES (Memory Erase Signal) connector
>
> MES Plug in Fuse box. It is a yellow connector with two wires in it that
is
> plugged into the fuse box, unplug it and pull it down. Once you have done
> that you can begin the process of erasing the memory. NOTE: This will only
> reset your SRS System if what caused it to trigger has been fixed, Ex:
> turning the ignition on with any SRS Plugs disconnected, such as pulling
> your seat out.
>
> 1st step in erasing the memory is to turn the ignition off and connect the
> SCS Service connector to the MES Plug,
>
> 2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds
> then go off.
>
> 3rd Disconnect SCS service connector for MES connector within 4 seconds
> after SRS indicator light goes off. SRS indicator light will come on
again.
>
> 4th Reconnect SCS service connector the MES connector within 4 seconds
after
> SRS light comes on. SRS indicator light will go off.
>
> 5th Disconnect SCS service connector from MES connector within 4 seconds.
> SRS indicator light will indicate that memory is erased by blinking 2
times.
>
> 6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and
> light should come on and go out like normal. You have reset your SRS
light,
> congrats.
>
> If it does not work the first time try it again, the timing has to be
> perfect. My first time it took me 3 attempts before it worked, but it did
> work.
>
>