1. turn ignition switch off, remove service connector cover2. connect (jump) the MES (Memory Erase Signal) connector (this is 2 pin connector wrapped on yellow plugged in the front of the underdash fuse box)3. turn ignition switch on4. SRS light will come on for 6 secs then go out, remove the jumper within 4 secs after the light goes out.5. the SRS light will come on again, reconnect the jumper within 4 secs after the light has come on.6. the SRS light will go off, remove the jumper with in 4 secs after the light has gone off.7. the SRS light will blink 2 times indicating the memory is reset.8. Turn the ignition switch to off and wait for 10 seconds.































www.hondapitstop.com