The timing belt went on my 89 Accord SEI. It's the 2 liter SOHC with auto
trans. No damage to pistons or valves and put a new one on it. The problem
is that now I can't turn the dist enough to get it to advance to the red
timing mark, where it used to be. I did this job once, several years ago and
didn't have any problems. I positioned the cam sprocket with the "up" mark
up and the little mark on each side even with the top of the head. I have
the crank at TDC. I made sure of it by checking the #1 piston's travel. The
flywheel, or whatever it is that has the marks, has, from retard side to
advance side, a hash mark and a "T" next to it. That checks out as TDC.
After that, there is about a half inch gap and then, what looks like the
letter (G) .. another gap and then about 4 hash marks with the middle one
red. After the red one is, what looks like the number "5". I assume that the
one to the left of the red is the number "1", making it (15), for the number
of degrease that it's supposed to be set before TDC. Anywhoo ... I can't
get it to advance past the (G) looking mark which is way before the red one.
I tore it back apart and rechecked the cam sprocket and the TDC mark ...
they are OK.

The procedure, according to the "Haynes" book, for setting ignition timing
is to disconnect and plug the two vacuum hoses that go to the advance and
then set it to 15 BTDC, reconnect the hoses and you're good to go. That's
how I did it last time. Don't know why I can't duplicate it.

I got a hold of an Accord service manual and it tells you to set it at 4
BTDC with the hoses disconnected and plugged. There is no 4 degree mark. I
guess supposedly, it's supposed to go to 15 after rehooking the vac advance?
I replaced the vac advance a few years ago. I just checked it and it holds,
with vac pump on either connection. It also mentions how to check for vacuum
from the hoses and suggests that if not there, it might be a problem with
the "Ignition control solenoid valve". To check that you are supposed to
have the engine running and warmed up. Anyway, I have it torn apart with
belt on and if I have to adjust the belt, now's the time.

It seems like, to be able to do it the Haynes way, I would have to move the
belt a tooth. That's the only way I'll be able to get it to advance the ign.
timing to 15 BTDC. Any help or thoughts on this would be greatly
appreciated. Thanks in advance