I did as best I could to reproduce the instructions from the Accord Owners Manual. The system is called "Homelink" in the manual. there are two procedures to program the remote; the first works in 90% of the cases.To start, erase any stored codes-- press and hold the twooutside buttons on the HomeLinktransceiver for about 20 seconds,until the red indicator flashes.Release the buttons, then proceed as followsUnplug the garage door openermotor from the electrical outlet.Hold the end of the garage dooropener remote 2 to 5 inches fromHomeLink. Make sure you are notblocking your view of the redindicator in HomeLink. (the ignition for the car may have to be turned on; it doesn't say if it does or not)Press and hold the remotetransmitter button and one of theHomeLink buttons at the sametime. While continuing to hold theHomeLink button, press andrelease the remote transmitterbutton every 2 seconds.If the red indicator in HomeLinkbegins to flash slowly at first,then rapidly, release bothbuttons, Plug in the garage door openermotor, then test the HomeLinkbutton by pushing it for about 1second.If the button works,programming is complete.If the button does not work, youhave a rolling code transmitter: ‘‘Training with a RollingCode SystemFind the ‘‘training’’ button on yourgarage door opener unit.unit. The location will vary, depending onthe manufacturer.Make sure you have properlycompleted the ‘‘TrainingHomeLink’’ procedure.Press the HomeLink button again.It should operate the garage door.The ‘‘Training HomeLink’’procedure trains HomeLink to theproper garage door opener code.The following proceduresynchronizes HomeLink to thegarage door opener so it sends andreceives the correct codes.Press the training button on thegarage door opener unit until theindicator next to the button comeson. The indicator may blink, orcome on and stay on. You thenhave approximately 30 seconds tocomplete the following steps.Press and hold the button onHomeLink for 3 to 4 seconds.Press and hold the HomeLinkbutton again for 3 to 4 seconds.This should turn off the trainingindicator on the garage dooropener unit. (Some systems mayrequire you to press the button upto three times.)