OK... Now depending on the kit that you got. there are two different kits available with different wiring harness. one uses the factory harness and the other uses an aftermarket syle harness. for the OE style harness your best bet is to consult a honda manual (helms) to have the wiring diagrams and will show you what and where each wires go. mainly it will be a harness that will plug into the fuse block and with a relay. then the harness will proceed up to the switch. on the other hand if you have an aftermarket harness then the process is pretty straight forward. i did this to my 92 SI hatch. you would first install the fogs on the bumpers. you will need to trim out the area on the bumpers that houses the fogs. you do not need to trim out the whole thing. BECAREFULL. the fogs actually go onto the bumper then once you have put the bumpers back on there will be a tab on the brackets that will bolt to the frame rail with the bumper on the car. so don't get too happy and start cutting out eveything. once you have taken out the bumper and look at the back you will know what i am talking about. there will be a haness that will plug into the fogs this harness will have a relay as part of the harness. once you have ran the wiring and there should be one wire for the ground one for constant power and one for an accesory power wire. the other side of the harness will simple be just plugged into the switch. again i do not know how ur harness is setup but this is how i did mine. if you have any questions don't hesitate to ask i will let u what i know. always glad to help out a fellow EG owner.haitech