Have the recall done by your dealer.
But, to answer your question, the new ignition switch has a ring in it to
read the code on your key, but the code must match what the computer on your
car has stored. The new keys must be programmed to the car by either reading
an old key (on a decoder) and then programming your new keys. Or all keys
and the computer can be programmed anew to match each other.
"Tiller" <stevenconly@hotmail.com> wrote in message
news:1151162707.492115.235890@y41g2000cwy.googlegr oups.com...
>I have a 1998 Honda Accord LX that I purchased used and the car has run
> fine up until a year ago where the car would just randomly shut off.
> After lots of trouble shooting I found that the problem was in the
> ignition cylinder, if I hit a bump the key would move slightly and the
> car shut off. I finally got around to replacing the ignition cylinder
> with one of the same from honda approx $160 from dealer to dealer (I am
> a Jaguar mechanic) it came with a new set of keys too so I figured the
> transponder code was in the ignition cylinder. I install it and the car
> doesnt start but turns over, I double check all my connections and
> still no luck. it is saturday and I have no way to get in touch with
> ALLDATA or the dealer to see if there is a special procedure. Anyone
> have any ideas?
>
> Tiller
>