View Single Post
  #9 (permalink)  
Old 27 Mar 2006, 06:46 pm
'Curly Q. Links'
Guest
 
Posts: n/a
Default Re: Following the ABS troubleshooting steps; Have any suggestions?

scube wrote:
>
> I pulled each of the four plugs out and ohm'd them. Neither was close
> to 800 ohms. The highest ohm was ~500, and the others were lower,
> like near zero. Could these be bad if they are too low in resistance?
> My understanding is that the sensors pretty much are coils, so low
> resistance would not be terribly abnormal, correct?


-----------------------------

'95 Odyssey was about 900 ohms all around. They are similar to the coil
in a doorbell, mounted around a permanent magnet. The rear ones on an
Ody can get a clump of iron filings on them which reduces sensitivity.

'Curly'
Reply With Quote