Hey all,
My Car is a 1993 honda Accord with manual transmission.
I've had a problem with my ABS functionality for a few years now.
My car was falling apart so I slowly started to fix all its problems.
CV Axles (for an ABS car), strut replacement, muffler replacement and
finally I got my cruise control working!! Now it's time to tackle my
ABS.

After starting my car the ABS light goes through its normal cycles
and stays off. When I drive for about 30 seconds the light comes on
and stays solid, no flashing. Following the manual's ABS
troubleshooting section, I believe I am to jumper the SCS to get the
DTC to flash on the instrument panel. I unplugged the B2 fuse
temporarily to reset the DTC memory thinking it was remembering a
previous code with no luck.

First, the only suspect connector I could find only turns on my
check engine light. I thought these two connectors were one in the
same, but I guess perhaps there is another for the ABS?

Going through the manual, some examples are given as to why the ABS
light would come on and their respective codes. E.g. parking brake
engaged for more than 30 seconds, the DTC is 2-1. However, my light
stays solid and I do not know how to get the code from it...

any suggestions? thanks,

scube