BigELilE05@msn.com wrote in news:1140095094.731514.21250
@g47g2000cwa.googlegroups.com:

'Curly'
>
> It's not the CV joints, it's the tie-rod and tie-rod end on the drivers
> side. I looked at teggers site and it doesn't go into the tie-rod.
>
> I know I can get the outter one loose and replaced, I'm just not sure
> about the inner part. If I gotta buy some special tools and it's a big
> PIA, I will just have to take it to someone, but I would rather do it
> myself.
>
>

If you're just replacing the tie rod end, then it simply unscrews from the
shaft and you screw on a new on. If you're going farther up to the rack and
want to replace the boot too, then you might need a tool for the boot
though, I was able to get them on and off without a tool. Boot replacement
becomes a clearance issue. Can you get in there to work?