TeGGeR® wrote:
> Andrew <ags9898@hotmail.com> wrote in
> news:eue6c15mp7r0pk850cmh1ncnjc7hdk9lu5@4ax.com:
>
> > Hi Everyone,
> >
> > I got a check engine light diagnosed & it came back as 'P1362:
> > Multiple misfire or No Signal In TDC 1 Sensor Circuit'. I replaced
> > my cap,rotor,wires & plugs ( they needed replacing anyways ) & am
> > still getting the same code.. I did a little searching around & it
> > appears that my next step would be replacement of the distributor.
> > Does anyone have any suggestions ? If its a loss of signal in the
> > sensor circuit could it be a loose wire and if so which one should I
> > check ?
>
>
>
> Was the light reset after the repair?
>
>
> --
> TeGGeR®
>
> The Unofficial Honda/Acura FAQ
> www.tegger.com/hondafaq/

Yes, I reset the light by pulling the backup fuse.. It came on again a
little while later.. I have also noticed that my car is idling a
little lower than normal ( approx 750--> 850rpm ). The mechanic I took
it to suggested that I change the cap, rotor, wires, plugs which I
did..

Any suggestions ?

Thanks

Andrew