On Sat, 25 Jun 2005 21:27:34 -0400, Andrew <ags9898@hotmail.com>
wrote:

>Hi Everyone,
>
>Well, to make a long story short I think I accidently ****ed up my SRS
>system. A friend and I were trying to diagnose a check engine light
>which had come on earlier in the day while I was driving my 1998 Honda
>Civic LX & I think we crossed the wrong connector when trying to get
>the ECU engine code. The connector which was crossed was hidden
>behind the dash/center consol on the passenger size and had 2 red
>wires going into it on one side and two green ones going out the other
>side. The yellow connector was being held in place by a light blue
>anchor.. Suffice to say crossing this connector did not provide us
>with the fault code so we pulled the radio fuse and plugged it back
>in. That reset the check engine light but now the SRS is on red and
>staying on.. Did we blow the SRS computer or just one of the sensors
>and if so which one ? Any suggestions as to fix this new problem I
>created for myself ? Is there a way to reset the computer ?
>
>
>Regards
>
>Andrew
>Ottawa, Ontario
>
>ags9898@hotmail.com
>
>
>
Disconnect the car batery for a couple of minutes and connect it back,
Chris