On 15 Apr 2005 00:01:20 GMT, "TeGGer®" <tegger@tegger.c0m> wrote:

>George Macdonald <fammacd=!SPAM^nothanks@tellurian.com> wrote in
>news:tp2s51ph2hi79h6815ttsjrtvnf9p6k4di@4ax.com :
>
>> On Wed, 13 Apr 2005 08:37:24 -0500, "Sean" <sguncav@hotmail.com>
>> wrote:
>>
>>>I know George MacDonald answered this question a few times already but
>>>I am still curious about the creaking sound coming from the rear
>>>suspension. He suggested spraying with water and greasing but added
>>>that was just a temporary fix. That creaking is driving me nuts, what
>>>is the permanent solution? New springs, struts?
>>
>> A permanent solution would involve Honda redesigning the spring and
>> lower perch on the shock with a plastic or rubber seat. Some mfrs,
>> like VW e.g., have used a polyethylene sleeve on the last coil of the
>> spring... which will eventually wear or break too.
>
>
>
>Funny you should mention that...
>http://www.tegger.com/hondafaq/tsb/civic/x01-907e.pdf
>
>This is for the Civic, and for the front suspension, but the idea is the
>same.

Yep that's the McCheapson strut - Honda's first abortive attempt at it. I
believe some Accords, mid 90s, had a similar "fix" for coil banging... see
below.

>> The Honda springs
>> I've seen have an epoxy coating which wears away to bare metal in ~18
>> months, which is when you start to hear the creak. Honda has used
>> sleeves as a TSB after-fit on some models but more to cure coil
>> banging than the creak.
>>
>>>I also heard about the balljoints seizing and snapping (saw the
>>>pictures on TeGGer(R)'s homepage). How do I check if they are ok or
>>>not?
>>
>> If they're >10years old, depending on your climate, the grease is
>> undoubtedly dried out to some extent.
>
>
>Not dried out grease, but water ingress. Water causes rust. Rust binds the
>ball, and then the post snaps, with, ummm, entertaining results.

Hmmm, well if there's enough grease in there it'll keep water out. Grease
does dry out and turn buttery eventually.

>> The creak I heard from the
>> front joints, or maybe upper bushings(?), is more of groan-type creak
>> and is most noticable with longer suspension travel over big road
>> surface irregularities, than the squeaky creak you get from the
>> spring/seat over minor bumps. I now consider greasing the ball-joints
>> an easy job - see: 0v1k51d5hlqkkj8i0b9rvalpmqfd0b2tb9@4ax.com
>
>
>George, what would have been excellent would have been photographs of your
>surgery. I could have put that up for everyone's edification.

It's pretty simple really - with a blunted needle just go at a slight
angle, with firm pressure and "wobble" the push. The silicone is important
to get it to slide in. On looking at my wife's Accord, which doesn't need
it yet, it might be more difficult due to more metal (chunkier hub carrier)
obstructing the path to the top of the bottom joint. The only digital
camera in the house is my wife's and I wouldn't think of taking it into the
dirty environment of a car job.:-)

--
Rgds, George Macdonald